Falcon 500 Powered by Talon FX

The Falcon 500 powered by Talon FX is a brushless motor with an integrated motor controller and high-resolution encoder, custom designed specifically for the FIRST Robotics Competition, through a collaboration between Cross the Road Electronics and VEX...

CANcoder

NOTE: Some Fall 2022 Units have a housing bottom with a tab that is too long.  See Section 6.1 of the CANcoder User's Guide for the recommended fix. TIP: CANcoder can be used with Phoenix Pro! The CANcoder is the next evolution in the line of CTRE...

CANivore USB Male C to Male C Cable

1 Meter USB Type C Male to Type C Male Cable - White

Falcon Motor Shaft - V2

Replaceable shafts for the Falcon 500 motor. Use these to replace shafts that have been cut, bent or damaged. The Falcon Motor Short Shaft is specifically cut to the correct length needed to use the Falcon 500 with a VersaPlanetary Gearbox.   Comes...

CANivore

The CANivore is a USB-to-CAN FD device. This device and its software will allow you to add additional CAN FD busses to the roboRIO and control supported CTR Electronics devices from your robot project. TIP: Click the FD Icon for a summary of what CAN FD...

Pigeon 2.0

Note: Latest Pigeon 2.0 hardware update requires a software update. Details available here. TIP: Pigeon 2.0 can be used with Phoenix Pro! Pigeon 2.0 is the next evolution in the family of Pigeon IMUs. With no on-boot calibration or temperature...

120 Ohm Resistors (25-Pack)

These 120 Ohm resistors are intended to be used with your CAN Bus systems as terminating resistors. Proper CAN buses, such as vehicle or industrial buses, have 120 Ohm termination resistors at the two ends of the bus harnesses.  CTR Electronics...

3-Pin Addressable LED Cables

Pair of Male/Female 3-pin addressable LED cables This is the standard connectorization for addressable LED strips  Wire a female cable to the CANdle to easily connect and disconnect from CTR Electronic's LED strips. Please see the table below for...

USB Type C Wire Breakout

0.3 (1ft) Meter USB Type C Male to Exposed Power Wires Can be used with the CANdle to power USB Type-C devices with 5V Red Wire +USB (5V), 22AWG Black Wire -USB (0V), 22AWG

USB Micro Power Wire Breakout

0.3 (1ft) Meter USB Micro Male to Exposed Power Wires Can be used with the CANdle to power USB Type-C devices with 5V Red Wire +USB (5V), 22AWG Black Wire -USB (0V), 22AWG

1m (3.3ft) Addressable LED Strip

Technical Specifications: Nominal Voltage DC 5V LED Model WS2812B (GRB) LED Density 60 LEDs/m IP Rating IP65 Lamp Luminous Flux 18 lumens Lamp Power 14.4W/m Length 1m (3.3ft)

5m (16.4ft) Addressable LED Reel

Technical Specifications: Nominal Voltage DC 5V LED Model WS2812B (GRB) LED Density 60 LEDs/m IP Rating IP65 Lamp Luminous Flux 18 lumens Lamp Power 14.4W/m Length 5m (16.4ft)

CANdle

The CANdle is a CAN-enabled individually addressable LED controller and a 5V high-efficiency DC voltage regulator all in one compact device. Featuring 8 on-board individually addressable RGB LEDs,  5V and pass-through VBat outputs with current sense...

Weidmuller Ferrule (Pack of 20)

Package of 20 Weidmuller brand Ferrules. We only sell Weidmuller brand ferrules made by the same company that makes the Weidmuller connectors used on the PDP, PCM, and VRM. This crimp-on connector for 16, 18, and 20 AWG wire makes it clean and easy to...

Silicone Wire - 12 AWG

The perfect wire for wiring robots cleanly and effectively. This is a flexible 12 AWG stranded wire utilizing a silicone based insulation making it ideally suited for power distribution in a robot. Use it with motor controllers such as the Victor SP,...

Power Distribution Panel Breaker

20, 30, or 40 Amp Snap Action Breaker used in the Power Distribution Panel This Snap Action Breaker is used in the Power Distribution Panel for limiting load currents to the rated amperage. This breaker auto resets: upon overload the breaker cycles...

Anderson Powerpole Contact

This is an Anderson Powerpole Contact to be used in conjunction with the Anderson Powerpole Housings (PP15/45 series). The housings are sold separately. Purchase the exact number you need here (max 100 per order).  

Steel Spur Gear (20 DP, Falcon Motor)

A steel gear with a diametrical pitch of 20, designed to interface with the Falcon 500's spline shaft. Comes with: (1) Selected Gear Type (3) #8-32 x 0.500" Star Drive Screw (3) #10-32 x 0.500" button head cap screw (3) #10-32 x 0.500" socket head cap...

Anderson Powerpole PP15/45

This is an Anderson Powerpole Housing. This connector solution makes wire-wire and wire-board electrical connections clean and robust. This housing can be used with a 15 A contact, 30 A contact, or a 45 A contact. The contacts are sold separately. All of...

SRX / Gadgeteer Data Cable Kit

This kit includes a 10' long data cable and 20 female 2x5 pin data connectors for making custom length SRX/Gadgeteer Data Cables. The kit includes enough data connectors to make 10 custom length data cables. The cable and connectors in this kit have...