Falcon Motor Shaft

Replaceable shafts for the Falcon 500 motor. Use these to replace shafts that have been cut, bent or damaged. The Falcon Motor Short Shaft is specifically cut to the correct length needed to use the Falcon 500 with a VersaPlanetary Gearbox.   Note:...

Steel Spur Gear (20 DP, Falcon Motor)

A steel gear with a diametrical pitch of 20, designed to interface with the Falcon 500's spline shaft. Comes with: (1) Selected Gear Type (3) #8-32 x 0.500" Star Drive Screw (3) #10-32 x 0.500" button head cap screw (3) #10-32 x 0.500" socket head cap...

Falcon Spline to 1/2" ThunderHex Adapter

ThunderHex adapter for Falcon 500 spline shaftThe Falcon Spline to 1/2“ ThunderHex Adapter allows you to easily drive any 1/2“ hex bore product with a Falcon 500 Motor, or support a Falcon Shaft with a ThunderHex Bearing.   This kit also comes with two...

Falcon Motor Spacer Pack

Additional spacers to help position items on the Falcon 500 Motor's shaft. Additional spacers to help position items on a Falcon 500 Motor's shaft. The spacing system is designed so that any type of spacer is in this kit, in addition to any Falcon...

Falcon 500 Hardware Kit

This kit should be used as an upgrade kit for Falcon 500's purchased before December 2020. It can be used for replacement hardware for Falcon's purchased after December 2020.This kit contains all the hardware needed to upgrade Falcon 500's that were...

16T x 9mm Wide Double Flange Aluminum Pulley (GT2 3mm, Falcon Motor)

A 16 tooth aluminum timing pulley designed to easily interface with the Falcon 500's spline shaft.This 16 tooth aluminum timing pulley is designed to easily interface with the Falcon 500 spline shaft. Synchronous timing belts and pulleys are lighter and...

VP Press On Motor Coupler (Falcon Motor)

The VersaPlanetary Motor Coupler is designed to couple Falcon 500 Motors with the VersaPlanetary.The VersaPlanetary Motor Coupler is designed to Falcon 500 Motors with the VersaPlanetary. The coupler slides right through the VersaPlanetary’s motor...