Falcon 500 Powered by Talon FX

NOTE: There is a known issue where Falcon 500 motors may not have adequate loctite applied to the shaft retention screws.  See the blog post with a message from VEX.   The Falcon 500 powered by Talon FX is a brushless motor with an integrated...

CANcoder

The CANcoder is the next evolution in the line of CTRE magnetic encoder products. As its name implies, this product is a rotary magnetic encoder that communicates over the CAN bus. Supporting CAN FD and CAN 2.0, this product provides the same position...

CANivore

The CANivore is a USB-to-CAN FD device. This device and its software will allow you to add additional CAN FD busses to the roboRIO and control supported CTR Electronics devices from your robot project. Features Reverse Input Power Protection ESP32 for...

Pigeon 2.0

Pigeon 2.0 is the next evolution in the family of Pigeon IMUs. With no on-boot calibration or temperature calibration required and dramatic improvement to drift, the Pigeon is the easiest IMU to use yet.  Features • Nine Degrees of Freedom (3...

CANdle

The CANdle is a CAN-enabled individually addressable LED controller and a 5V high-efficiency DC voltage regulator all in one compact device. Featuring 8 on-board individually addressable RGB LEDs,  5V and pass-through VBat outputs with current sense...